Field manual · Vulpa H750E

Guided Assembly

Steps done0/105 steps0%

…

Burnie's 115-page build manual, page by page — with the screw callouts indexed and every hard-won lesson from his 6-hour video series pinned to the exact step where it saves you.

Follow along on YouTube: ▸ Part 1 · ▸ Part 2 · ▸ Part 3|⇗ Get the files|⇗ RC 1/14 Community

⚑ Red flags — read before you build

UndercarriageDo NOT assemble rollers before paint — paint fouls the bearings. Press bearings in early, hang the rollers after paint.▸ P1 12:54
OvercarriageInstall the light in the yellow corner piece BEFORE mounting the piece — retrofitting it is a nightmare.▸ P2 26:15
Final AssemblyValve block servo screws ship jammed all the way down → the servos overload and overheat. Back out ALL linkage screws before first power-up.▸ P3 29:24
Final AssemblyAll valve block fittings ship loose — tighten every one before install. His only leak was an untightened fitting.▸ P3 4:26 ▸ P3 33:22
Final AssemblyCut the red wire on ALL ESCs except one (a single BEC powers the receiver). NEVER cut red wires on servos.▸ P3 14:48 ▸ P3 23:39
Final AssemblyThe pump cannot pick up oil below 50% tank — never run it dry. ISO 32 oil. Lock the endpoint so the pump cannot reverse (one side 40%, other 0).▸ P3 25:46 ▸ P3 32:33