Cylinder Line Brace

0/2 done

Community fix shared by Ryan Lofgren in the RC 1/14 Facebook group — thanks, Ryan! A printed brace that clamps the boom-cylinder hard lines so vibration cannot crack them at the fittings.

Hardware: 4× M2x8ST hold the center clamp bar; 2× M2x10ST hold the line clips at the cylinders.

Print it from the Parts board under "Community fixes" — the STL downloads from your locker as a zip (it is a heavy mesh).

⇗ Shared in Burnie222rc’s Designs - RC 1/14 Community

Read first

Mount points & screws

M2x8ST x4 (clamp bar)M2x10ST x2 (line clips)Dual cylinder hard pipe clamp

Green = the clamp bar between the cylinders (4× M2x8ST). Red = the hard-line clips at each cylinder (M2x10ST).

1 / 2 · ← → turn · D done · + − zoom